在GE冰箱出厂时，预设了冷藏室37°F和冷冻室0°F，允许24小时，温度稳定到预设推荐设置。
The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the freezer compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings.
温度控制可以同时显示设定温度以及profile冰箱的实际温度，根据使用情况和工作环境实际温度可能与设定温度略有不同。
The temperature controls can display both the SET temperature as well as the actual temperature in the refrigerator and freezer. The actual temperature may vary slightly from the SET temperature based on usage and operating environment.
注意：冰箱附带的保护膜覆盖温度控制。如果在未移除这部分即安装时，立即将其取出。
NOTE: The refrigerator is shipped with protective film covering the temperature controls. If this film was not removed during installation, remove it now.
要改变温度，按下并释放升温或降温按钮。SET将在点亮显示，以及设定温度。要改变温度，可轻按升温或降温按钮（而SET亮），直到所需的温度被显示。冰箱的温度可以在34之间°F和47°F之间进行调节，冷冻室的温度可以在-6°F至+8°F之间进行调节。
To change the temperature, press and release the WARMER or COLDER button. SET will illuminate in the display, as well as the set temperature. To change the temperature, tap either the WARMER or COLDER button (while SET is illuminated) until the desired temperature is displayed. Refrigerator temperatures can be adjusted between 34°F and 47°F and the freezer temperatures can be adjusted between –6°F and +8°F.
停止按动该键10秒钟后，最后的设定温度值被确认并储存，显示屏恢复显示冷藏室温度。几个调整可能是必需的。每次调整控制，允许24小时内冰箱达到你设定的温度。温度设定值即使在断电之后，也无须重新设定。
Once the desired temperature has been set, the temperature display will clear after 10 seconds. To display the temperature, the DISPLAY TEMP button may be tapped.
Several adjustments may be required. Each time you adjust controls, allow 24 hours for the refrigerator to reach the temperature you have set.
